Honda Goldwing 1500cc InstaTrike Manual Installation Instructions

Download
Important Notices y Remove all preload (air) from rear suspension of motorcycle after initial installation of InstaTrike. Readjust preload as desired. y InstaTrike is designed for use on paved surfaces only . Use of InstaTrike on unpaved terrain may void warranty. y Installation of InstaTrike requires your motorcycle to be level. Some motorcycles are not level when on the center stand. Level the motorcycle by placing spacers under the center stand as needed y When installing trailer hitch attach all bolts and brackets loosely. After all bolts and brackets are in place tighten all bolts. y Using the enclosed wooden risers under each InstaTrike wheel may make installation and removal easier particularly if traction kit is installed.
Installation Checklist : Review entire installation manual, Loosen saddle bags and remove rear fender cover, Modify rear fender cover, Install receiver hitch and double check all bolts, Remount rear fender and tighten saddle bags, Assemble InstaTrike hitch cart, Attach InstaTrike to motorcycle via receiver hitch, Attach leanstop brace bolts to receiver hitch, Align InstaTrike wheels, Double check all bolts for tightness, Test ride InstaTrike slowly in an open area to familiarize yourself with handling characteristics.
Receiver Hitch Installation NOTICE: Install all bolts and brackets loosely until all bolts and brackets are in place 1) Place motorcycle on center stand. NOTE: Some Goldwings are not level when on center stand. Shim underneath center stand to level motorcycle. 2) Remove side covers 3) Loosen saddle bags and remove rear fender cover. 4) Modify rear fender cover. See diagram 5) Remove muffler bolts. Replace with enclosed muffler bolts. (hex bolt head toward inside with washers on bolt head side) This allows clearance between the hitch and muffler bolt. 6) Replace existing motorcycle rear crashbar bolts with those provided (2 each side). Ensure new crashbar bolts are securely tightened before attaching brackets A and B. 7) With brackets A (left) and B (right) attached to bottom of forward arms of hitch, slide hitch under bike and loosely attach A and B to bottom of rear crash bar with provided U-bolts. Use caution not to crush crash bar with U-bolt 8) Attach top portion of bracket C to crossbar on rear sub frame with saddle U-bolts provided. It may be necessary to pry plastic from inner fender up slightly to allow for U-bolt installation. NOTE: Bar on top of bracket C must be in direct contact with rear sub frame crossbar. It may be necessary to push a plastic tab from the inner fender in so as to allow direct contact.